How to add custom entries from the Impero.ini file to your configuration package (.MST) using Pack’n Deploy
Modified on: Mon, 20 Sep, 2021 at 12:16 PM
A typical installation of Impero Connect Host (or Guest) includes a Impero.ini file located in C:\Windows. This file contains some settings that cannot be access through the program’s GUI. There are several entries that are added to this file automatically as part of a standard installation. Occasionally some users will add some custom entries to this file that will fine tune the performance of the Impero module. If you have added any custom entries in the Impero.ini that need to be included in your distribution package for deployment you may observe the following step within Pack’n Deploy.
Go to the Advanced tab.
At the bottom select the INI Settings tab.
Then add a check mark next to any custom entries you wish to include. (Do not select every entry, only select the one(s) you have added or changed.)
When you finish building the .MST it will now include any custom INI entries you have selected.
Did you find it helpful?
Can you please tell us how we can improve this article?